20 Jan
2015
20 Jan
'15
2:01 p.m.
On Sun, Jan 18, 2015 at 07:02:22PM -0500, Kyle Owen wrote:
I wanted to extend this to a VC8-E emulator, again in the simplest way
possible. I am sending out the X- and Y-coordinates for the point over
TTOX0, but seem to be encountering some problems. I noticed that it likes
to get hung up on a TSF (6411) instruction, causing it to keep looping even
in single-step mode! Assuming everything is buffered, I would be under the
assumption that TSF would almost always skip with a successful device send.
I noticed David Gesswein opened up a somewhat related issue, now marked as
closed, in October 2013. https://github.com/simh/simh/issues/85
SIMH has some delays to better match real hardware behavior. From my
memory on when I was looking at this it still doesn't instantly raise
the flag though allows much faster transfers than a real serial port.
https://github.com/simh/simh/issues/86. The delay is in cycles not
real time so single step still needs to execute the same number of
cycles/instructions.