14 Jun
2015
14 Jun
'15
1:45 a.m.
On Jun 14, 2015, at 1:02 AM, Mike Ross wrote:
I can't even see the hardware messages at
power-on; just garbage - on both
systems, at every baud rate I've tried on the emulator. Nowhere near
booting OS.
If you hold down STOP-D while powering on, the system will go into diag mode. It'll
show you extended diagnostics on the serial port, using 9600 8N1. This may give you extra
information about the nature of your problem.
I haven't double checked that the serial port parameters do reset in this mode, but
several other important things for sure do.
ok
bear.
--
until further notice