Removing PSU from CDC 9766 drive

Since it appears no one can rescue the CDC 9766 drives, I've begun stripping some bits from one of them (removed one board set already) and am preparing to remove the PSU during lunch or my next break. Now then, as time may be in somewhat short supply, can anyone give kindly me any hints for the easiest way to do this? Noticing the screws in the side of the slide-out rack, I'm wondering if removing the two screws on each side will remove it. There also appears to be an air-hose (used to cool the PSU?) that will have to come off. Is there some way to eaasily just disconnect the sliding mechanism without removing the screws? It also looks as though there's some sort of braided wire (wires?) going into the PSU with no connector that can be disconencted... blast... the one thing I've misplaced was my wirecutters, which I, hopefully, won't need. Any other suggestions for removing any other easily removeable bits (heads, motor?)? How do I lift the lid on this drive to access the front panel switches to remove the switches and light-bulbs? (sorry for the unhackish question, but time's a bit short). -- R. D. Davis rdd(a)perqlogic.com Be careful what you wish for --- you http://www.perqlogic.com/rdd may get your wish ...and it might not Tel: (410) 744-4900 be what you were expecting.