14 Jul
2021
14 Jul
'21
12:32 a.m.
On 13 Jul 2021, at 23:20, Antonio Carlini via cctalk
<cctalk at classiccmp.org> wrote:
On 13/07/2021 22:34, Douglas Taylor via cctalk wrote:
Bear in mind I?m an old DEC head and have been since the early 80s ;) Though I HAVE seen
customers get RJ11 cables jammed in MMJ ports before, because ?they look alike?.
Both of you missed my sentence where I said ?It doesn?t matter what position I have S3
in?, and IIRC even with S3 set to graphics you would still get a dead sergeant on a VT
once init had completed, you just wouldn?t see POST.
Anyway, I?ll hook up a VT today at some point and see if anything happens.
Cheers
--
Adrian Graham
Owner of Binary Dinosaurs, the UK's biggest private home computer collection?
t: @binarydinosaurs f: facebook.com/binarydinosaurs
w: www.binarydinosaurs.co.uk
On 7/13/2021 3:30 PM, Adrian Graham via cctalk
wrote:
If you look from the front it's on the right hand side and marked
"S3", between the grey reset switch and the keyboard connector. I think that S3
needs to be UP otherwise it would expect a monitor and keyboard to be attached.
The MMJ connector is on the back (but obviously Adrian has found that ... or he's
pushed really, really hard into either the keyboard connector or the phone connector :-))
Hi folks,
Powering up with nothing attached apart from an MMJ/H8571 cable I get
nothing on the console, I'm using PuTTY via a genuine COM1 port on a PC
which is one level above what I used last time I powered the machine up
(FTDI USB adapter to a laptop). Diagnostic LEDs cycle through the tests and
end up at '1111 0011' which according to the manual is 'entering the
console program'.
There are 2 ways to have a console on the VAX4000/VLC. A switch on the back
selects either; (1) graphics console mode, or (2) terminal attached to the serial port.
It sounds like you have the switch set to graphics console mode, in that case you get
nothing from the serial port.
I can't remember where the switch is on the back, bitsavers or someone who remembers
can help.
Doug