HP-IB Mass Storage Emulation (Help)

A PC's parallel port CANNOT emulate an HPIB bus without a good deal of external hardware, and if you did the performance would be terrible, nearly unusable. Why not simply get a National Instruments HPIB card and write some code to turn a standard PC into your emulated HPIB stroage system? No hardware needs to be fabricated, its a fairly simply matter of writing some code so some part of the PC's hard disk is used to emulate the HPIB disk. Also HPIB disks are VERY common, and also VERY reliable. Ask on this listy and you will hear stories of CS/80 drives from HP being underwater, thrown into dumpsters, and other suffering forms of abuse without any problems at all. As for capacity issues, many HPIB drives (like HP's CS/80 drives) have a rather low limit (in modern terms) on their maximum capacity due to the limited disk address field size. Modern devices like ATA (IDE) drives are many times larger than this maximim capacity. So a true emulation of these devices (needed for driver compatibility) will not be able to use much of the modern drives actual capacity. Given that you can find a working CS/80 drive on eBay for short money, is this project worth doing? If so, I'd have to reccomend using a commercial HPIB interface board and some code running on a PC rather than developing any custom hardware. It pains me to say this, as I'm a hardware engineer, but sometimes the best solution is not to design any hardware. This is exactly such a case. Vassilis Prevelakis wrote: >I have been working for some time on a pet project to make a mass >storage emulator for HP-IB systems. Given the massive improvement in >capacity that has taken place the past 10 years, most mass storage >devices from the 80s look pathetic. > >For example, take the HP 9133H which is a massive unit that can store >about 5Mb. Even the compact flash cards that are bundled with popular >digital cameras can do better than that. > >I started my project by trying to utilize the HP-IB drivers that are >part of the NetBSD Open Source Unix clone (which runs on the HP 300 >series), but I have come to realize that the HP-IB cards are the >creating a new legacy issue. > >Open Source drivers for HP-IB cards are very hard to find and thus any >solution that depends on them becomes de facto legacy (once the card >itself is no longer sold, finding the card becomes almost as difficult >as finding HP 9133H drives). > >So I looked hard at the HP-IB bus itself (using the schematics from the >Series 80 adaptor) and it looks like a simple parallel bus. So why use >a custom card, if the PC parallel port can be adapted to drive an HP-IB >bus. > >If the PC parallel port can be used, then I can port the NetBSD drivers >to use the parallel port, rather than the HP 300 HP-IB interface. The >NetBSD drivers also support SS-80 compatible mass storage devices, >which means that the implementation can be verified against a real >HP-IB mass storage device. If this works than the drivers will have to >be modified so that they become a mass storage "server" rather than a >"client" (i.e. a device that responds to mass storage requests, instead >of a computer that issues such requests). > >Small i386 compatible single board computers are easily procurable and >embedded versions of *BSD and Linux systems run on these SBCs (they >even accept compact flash cards or more traditional hard disks). This >means that we can make a mass storage device that can physically fit >inside the cabinet of the main unit (e.g. Integral PC, or HP-87). > >Anybody willing to provide assistance to this effort, is welcome to >contact me. However, I think that going through this list may be >more beneficial so that other people can contribute in the technical >discussion. > >**vp