HP tape drive novel repair

I?m in the process of building another HP2000/Access TSB system. I pulled a 7970E tape drive out of a shipping container (I had not opened the shipping container since I bought it about 8 years ago). When I got the unit on the bench to give it a going over, while it looked pristine ? someone had dropped something very heavy (heavy enough to severely deform ?? steel) on the top of the unit. My thought (given there?s not a shortage of open space inside the chassis) was to put a car jack inside and jack it up thus pushing out the top. My concern there was that there would be an ?equal and opposite reaction?). Perhaps a 2x4 that goes side to side under the jack would alleviate this. But on freenode #classiccmp (where I hang out pretty much every night), PJustice and Sark both had similar ideas for an alternative approach that took advantage of the fact that the top of the chassis has a lot of vent holes on top. I implemented their approach and it worked very well so I thought I?d document it with pictures and post here. I should note that this approach only works because the angle iron I used was 14ga. Anything less would just bend itself. If I had facilities to cut the angle iron, I would have put a piece on top and on the bottom but I don?t. Failing that, I just had to pick specific spots on top to ?pull out? more carefully. As you know when steel bends it stretches so it would be impossible to get it back 100% perfect but I?m pretty pleased with the results. If you want to use this method and don?t have convenient holes already present from the manufacturer, you could always drill one or two holes to make it work. Note that without the wood blocks you can pull it straight but it might bend back (albeit less so), but with the wood blocks you can pull it further than straight so it bounces back ?mostly straight?. http://www.ezwind.net/hp2000/7970E/ And if you want to follow the build of the 2000/Access IO-rack (which holds tape, terminal controller and bulkhead, and disk controller subsystem): http://www.ezwind.net/hp2000/IO-Rack/ THANKS SARK AND PJUSTICE J J