Tried to power up a Sun 3/80 mainboard...
Inductor L0500 (right near the power input) (I assume this is an
inductor by the L0500
marking on the PCB) smoked.... (pink smoke no less)
This sseems to be the day for smoking indcutors :-)
Anyone familiar with the 3/80 to give an idea of why this might have smoked.
I've never seen this machine, but from the location of the component, and
the fact that it's an inductor, I would asseum it was part of a DC power
line filter, and it smoked because of a short (to logic ground, most
likely) 'downstream' of said component.
My first suggestion is to desolder the indcutor from the PCB. Then trace
one of the connections back to the PSU input connector, which will tell
you which power line it's associtated with. If you're lucky it'll be
something like a +12V rail, not used by many components. If you're
unlucky, it'll be the 5V rail that goes everywhere...
Msot likely you'll find the 'other' side of the inductor postion on the
PCB -- the one not conencted to the power connector -- has a low
resistnce to ground.
There are many 'techniques' for finding such shorts. Pulling all socketed
devices is a good first step, if the short goes away, you know it's one
of the chips you've pulled. Suspecting tantalum capacitors is another
good idea :-). More logical is the idea of applying a low voltage between
the output side of hte inductor and ground, so that a mdoerate current
flows (I would guess areound 1A would be OK here), and using a sensitive
millivoltmeter to measure the voltage drop across components. The shorted
one will test lower than all the others (due to the drop along the PCB
tracks), but you do need a good millivoltmeter for this test.
-tony