Why don't you learn that you don't always know what you're talking about?
Indeed, the first step level of the 6800 had an undocumented opcode that
results in 3 particular transistors turning on that connected Vcc to GND.
The damage caused by these three transistors shorting damaged the silicon in
the immediate area, rendering the CPU useless.
But since the shop I worked for only flamed out 2 Sphere-II 6800 CPUs
before the Motorola FAE defined the problem and gave us new parts, it
probably didn't really happen, since you said it's fiction.
--John
-----Original Message-----
From: cctalk-admin(a)classiccmp.org [mailto:cctalk-admin@classiccmp.org]On
Behalf Of Richard Erlacher
Sent: Friday, June 07, 2002 10:16
To: cctalk(a)classiccmp.org
Subject: Re: [CCTECH] Interesting tidbit on 6502
It's crap like this that causes the confusion that Steve pointed out.
Why can't we keep some distance between fact and facetious fiction for the
benefit of those whose knowledge is largely semantic?
Dick
----- Original Message -----
From: "J.C. Wren" <jcwren(a)jcwren.com>
To: <cctalk(a)classiccmp.org>
Sent: Friday, June 07, 2002 7:26 AM
Subject: RE: [CCTECH] Interesting tidbit on 6502
This only occurred in the very first step level of the
6800 released,
IIRC.
You'd be hard pressed to find any parts with this
flaw. And even if you
should wind up flaming a part (which are astromical odds these days),
6800s
are still readily available.
--John
-----Original Message-----
From: cctalk-admin(a)classiccmp.org [mailto:cctalk-admin@classiccmp.org]On
Behalf Of Ben Franchuk
Sent: Friday, June 07, 2002 02:04
To: cctalk(a)classiccmp.org
Subject: Re: [CCTECH] Interesting tidbit on 6502
Loboyko Steve wrote:
I'm building a 6800 machine right now and I was
wondering about this "Halt and Catch on Fire"
instruction. Is this for real. This is a serious
question. Is there actually an instruction that will
overheat the chip?
Not on the 6800 but I believe some FORTH chips have that problem.
This instruction for the 6800 if remember right just continually
increments the address bus, ignoring any data read. Only a hard
RESET will reset the machine from this state. I think the opcode
is $00.