26 Mar
2018
26 Mar
'18
1:08 p.m.
So, from what
I can see, the drive should spin up correctly, but for
some reason it goes into fault mode. I am right in thinking that upon
load, the heads should continue moving forward until the first track is
found, right? I should not have to perform a seek manually from the PDP?
If this is not the case, perhaps there is something else wrong.
I?m not an RL02 hardware expert at all, just a daily user back in the
day. I?m reading this assuming that at all times the drive is
correctly hooked up to an RLV12 in a running PDP with the correct
cable and termination present on the drive? If it isn?t you?ll get a
fault condition instead of ready after spin up.
A