1 May
2020
1 May
'20
6:40 p.m.
On 5/1/20 4:50 PM, Alan Perry via cctalk wrote:
All of the QIC-24 cartridges sitting next to me right
now have posts
that are machined with 1-2mm deep tape guides. I don't see how to
install tubing over the posts and have the guides still do their job.
As I noted, I have tried isopropyl alcohol to clean them off but they
still stick. Is this something that baking will help with? Maybe using
acetone instead of alcohol to wipe the posts down as well?
If you wipe with alcohol, can you still see crud on the posts? If so,
you'll need something stronger. Acetone might do, or MEK.
But if alcohol cleans the posts, that's not the problem. You could try
backing, but I don't think that will work either if the problem is in
the binder.
--Chuck