4 Nov
2018
4 Nov
'18
1:36 p.m.
Just had a look to this manual:
http://www.bitsavers.org/pdf/dec/pdp11/pro3xx/EK-PC350-TM-001_Professional_…
5.2.3.4 Power-Up Self-Tests, this section mentions the existence of rom
containing basic power up tests. I assume you are not even getting there
and your system fails to execute from this rom and report any errors on
screen?
In such case, A) is your cpu working? B) Is the rom code correct?
On Sun, Nov 4, 2018 at 10:11 PM Rob Jarratt <robert.jarratt at ntlworld.com>
wrote:
-----Original Message-----
From: Eduardo Cruz [mailto:edcross at gmail.com]
Sent: 04 November 2018 13:47
To: rob at jarratt.me.uk; Rob Jarratt <robert.jarratt at ntlworld.com>;
General
Discussion: On-Topic and Off-Topic Posts
<cctalk at classiccmp.org>
Cc: Tony Duell <ard.p850ug1 at gmail.com>
Subject: Re: Datasheet for a NEC Chip in DEC Professional 350
A constant pulsing reset is usually a watchdog at play. Hardware
watchdogs
are usually implemented in systems to reset
everything should the system
not meet one specific criteria: eg cpu touch one memory address before X
amount of time, or pcb voltage lower than X volts, etc.
Watchdogs are also usually found as software routines executed by the cpu
also looking for specific conditions. These rarely issue a reset hardware
signal,
just restar the program.
It looks to me like the reset is every 10us. I don't know how long the
watchdog is likely to be, the technical manual I have doesn't seem to
mention it in the section on the reset logic. I am still trying to find the
source of the signal that seems to be in the "wrong" state.
Regards
Rob