1 May
2019
1 May
'19
12:54 p.m.
On 30/04/2019 10:25, Huw Davies via cctalk wrote:
I know later 780s (probably with an upgraded memory
controller) supported 64MB of memory.
I have used VMS 1.6 and started managing VMS systems around the 2.4 timeframe.
I haven?t looked but does the simh 11/780 also provide PDP-11 compatibility mode? You
used to run a very large amount of -11 code in VMS 1.x..
I may have missed some of the thread, so this might be old news ...
The VAX-11/780 was followed by the VAX-11/750 and that needed (iirc) VMS
V2.0.
The VAX-11/730 was next and that needed VMS V3.0.
Then (I think) came the VAX 8600 and that needed VMS V4.0. That (I
think, but I can't find anything to support this right now ...) is when
the last of the PDP-11 compatibility code was finally removed.
So I think that to use anything pre-V4.0 you need compatibility mode
support in SIMH. But that seems to be there.
I've not used anything older than V3.x ... I remember command line
recall arriving, so I expect that happened in V4.0.
I would expect V1.x to feel distinctly clunky in comparison ... to V4.x
and later.
Still a fun exercise though I would think.
Antonio
--
Antonio Carlini
antonio at acarlini.com