9 Nov
2015
9 Nov
'15
3:26 p.m.
The cause of my panel chipping is very much finger contact at the edge of the cut panel.
There is the decay starting at the edge above all the switches and it is worse above the
"deposit" switch.
The rest of the panel other than these edges seems properly intact, but I am worried about
sealing off the flakey edges so environmental humidity, etc doesn't continue to
permeate through the fragmented edges of the paint.
I don't understand why the operator felt the need to get their oily paws all over the
panel when toggling, the edge of the switch is sufficient, but that is spilled milk. ;)
- Ian
Sent from my iPhone
On Nov 9, 2015, at 15:11, Al Kossow <aek at
bitsavers.org> wrote:
On 11/9/15 3:04 PM, rod wrote:
2. Screen Print first holes second.
That was clearly the case on the panel that I sent scans of to you
and I mentioned that they had milled off some of the white lines around
the cutouts for the paddle switches.