22 Oct
2020
22 Oct
'20
2:33 p.m.
On Thu, 22 Oct 2020, Chuck Guzis via cctalk wrote:
Following the idea however you can use a wire-to-board connector housing
like from Harwin M20 series with just empty contacts inserted. They are
widely available and start from 1x1 even.
<https://www.harwin.com/connectors-hardware/pcb-connectors/2-54mm-pitch-pcb-connectors/>
Maciej
A variation on
the connector idea: use an insulation-displacement type
connector (the kind that you mount onto a flat cable assembly) without
the cable. Just snap on the cover over the i-d pins and you have a
fully insulated assembly with the pins acting as spring clamps for the
jumper pins.
That's not terribly useful when you have only one or two positions to
protect, is it?