Chuck Guzis wrote:
On 10/13/2013
01:22 AM, Holm Tiffe wrote:
OMG...in almost the entire world PSU's are
working bad because of the
50Hz?
What about 400Hz from airplanes?
Not all airplanes--CDC used an MG set that put out 3-phase 400Hz.
With a full-wave (bridge or star) rectifier, you got mostly DC with
only about 4% ripple at 400*6 = 2400 Hz.
On the other hand, I've worked on some old (it was old when I worked
on it a long time ago) 110V 25Hz equipment. The transformers were
huge in comparison to their 60 Hz cousins and rattled rather than
hummed. You could even see flicker in incandescent
lamps--mercury-vapor lamps would drive you crazy.
Up until the 1950s, most (maybe all) of Ontario and some portions of the
US near Niagra Falls used 25 Hz electric power. I just did a Google of
when the conversion to 60 Hz took place. I discovered that at least a
few industrial users continued to use 25 Hz long after the conversion
of residential use to 60 Hz in Ontario some time in the 1950s. At this
point, there seems to be little, if any, 25 Hz production of electric power
left at Niagra Falls.
And YES!, I also remember the flicker from lighting when 25 Hz was
used even though I was about 20 years old at the time. That was
around 55 years ago (I turned 75 in July). If I remember correctly
(as you stated above), while the flicker from mercury-vapor lamps was
excessive, the flicker from ordinary incandescent lamps or bulbs was
noticible, but quite acceptable, having seen only 25 Hz powered bulbs
all of our lives.
I don't remember the transformers having a rattle, but then I was not
very concerned at the time.
Jerome Fine