12 May
2016
12 May
'16
11:30 p.m.
On 5/13/2016 1:13 AM, Eric Smith wrote:
Jim
On Thu, May 12, 2016 at 9:38 PM, Jim Brain <brain
at jbrain.com> wrote:
But, is it so
short that it would not touch the PCB when soldered? If
not, I think you're OK.
Not sure if I am completely understanding the
concerns with the switches,
but:
* I would install the switches and run the top nut out to the very
end, then back the inside nut up to it on the other side of the bazel
* Once all switches are installed, then insert the board and solder.
Part of the
problem is that with the commonly-available switches, the
push-button has a significantly shorter bushing than the toggles.