4 Apr
2003
4 Apr
'03
11:39 p.m.
----- Original Message -----
From: "SPC" <spedraja(a)ono.com>
To: <cctalk(a)classiccmp.org>
Sent: Saturday, April 05, 2003 7:32 AM
Subject: Re: HP9885 8" floppy unit
Hello, Robert:
Hi!
* What model of graphic screen can I use with the 380
? I should like to
know
about one (or more) model with all its identificacion data to search it in
eBay
or some reseller.
My 380 has an A1416A Kathmandu (a.k.a. Color VRX) (1280x1024 @ 60 hz, 8
bits, DIO-II). It has 3 BNC sync on green output, you'll need either an
adapter to a VGA monitor or a monitor with 3 BNC.
* What model of serial terminal or screen can I use
with the 380 to plug
into
the RS-232 port of this computer ? Same than previous.
Any null-modem cable to a peasea set to 9600,8N1 should work. Note,
however, that the serial console (vs the graphics head/HIL keyboard) is
selected by a firmware command. The commands can be entered blindly without
a monitor attached, but a HP-HIL keyboard *MUST* be used if it is not set to
a serial console already.
You can find some more info on the page for the hp300 port of NetBSD,
http://www.netbsd.org/Ports/hp300, and Jim Conrad may have some parts
avaliable, you can find his original post in the classiccmp archives,
http://www.classiccmp.org.
(Of course I accept all reasonable offer from somebody in Europe. This
includes
one GPIO board)
How many RAM boards are installed?
Thanks and Greetings
Best Regards
Sergio
Bob