2 Dec
2014
2 Dec
'14
2:54 p.m.
On Dec 2, 2014, at 14:46 , Brent Hilpert <hilpert
at cs.ubc.ca> wrote:
If, for example, Q402, R414 or R413 failed open there would be no current supply for the
V coil. You said you were getting some variation with the V centering, so, yes, the
problem may well be elsewhere.
That's about what I was thinking. The horizontal line is near the center of the
screen, and can be moved up and down with the centering control. If just one side of the H
bridge was broken, then I'd expect to see a badly distorted raster on one half of the
screen. So, that's why I suspect that the ramp isn't getting generated. I'll
do some more poking around to see if any signal is being fed to IC402 by IC401.
--
Mark J. Blair, NF6X <nf6x at nf6x.net>
http://www.nf6x.net/