23 Dec
2017
23 Dec
'17
4:32 a.m.
2017-12-23 10:08 GMT+01:00 Fritz Mueller <fritzm at fritzm.org>:
Hi Mattis,
Yes, the oscillator seems to work. But it is a pain to work with the VT52
since the print set has very little information. Where is the component
list? I cannot verify which PROM should go into what location. And the damn
boards doesn't have any component designator anywhere, nor is there
anything on the component placement info in the print set on the data path
board.
The PROMs in my machine are: 23-124A9, 23-125A9, 23-126A9 and 23-127A9. Is
this the same as your VT52? Apparently there is an earlier PROM set as
well.
It would be very nice if you could tell me the location of the PROM chips
as well.
/Mattis
On Dec 23, 2017, at 12:08 AM, Mattis Lind via
cctalk <
cctalk at classiccmp.org> wrote:
Anyhow, the VT52 boards are dead. ? The terminal uses 4 pieces
of 256 by 4 bipolar PROMs for a total of 512 bytes of microprogram.
Has anyone dumped the contents of these so I could verify them?
I have a restored VT52. Taking a peek, I see these PROMs are socketed, so
I can pull mine this weekend and give them a read for you no problem.
I actually had a lot of trouble with a flaky oscillator when I was working
through my VT52, but it sounds like your?s is going fine if you are
observing the whole timing chain including video sync?
cheers,
?FritzM.