11 May
2003
11 May
'03
12:05 a.m.
On May 10, 19:20, Zane H. Healy wrote:
I'm fairly sure it was set up that way to have redundant power (from
two different sources).
It has three connectors on the front; two 50-pin high-density
D-connectors (like SCSI-2 conectors) and an RJ11. I assume those
50-way connectors are DSSI, and the RJ11 is for a terminal?
Yes, it is. Two of them, in fact. The module is in the top, inserted
RZ29B-VA, it says on the outside.
Ok, so I shouldn't just dump it, then ;-)
To be honest, though, I don't think I want to keep it. I have two
MicroVAXes, a uVAX-II in a BA23, and a uVAX 3100 (DV-31AT1-A, on the
label on the back). Both have internal drives. I'm not likely to use
either for anything serious, and I need the space the StorageWorks unit
is occupying.
on my VMS
systems. I've got a BA350 attached to the PWS 433au I use as
a server via a Narrow SCSI card.
>I have a StorageWorks unit that's surplus to
requirements. It's a
>floor-standing box, complete with the doors and keys, 2 PSUs, and
some
"innards". Can anyone tell me if all thse bits belong in the same
unit?
2 x SWXBP power supply
Unless the HSD10 is pulling a LOT of power, you should be able
to get by using just one of these, while having two gives you
redundant power, I prefer to have the slot open for another device. 1 x HSD10-AA
DSSI-SCSI controller (what does this do, exactly?)
As mentioned, it lets you use SCSI devices on a MicroVAX with DSSI. 1 x 70-32155-01
8-bit interface (SCSI? or what?)
Does this plug into the end opposite the powersupplies? It
sounds like you've got a BA356 shelf. If so, I'm envious,
I've only got BA350's, the BA356 supports both 8-bit and
16-bit interface modules. Oh, yes, if we're talking about
the same thing, it's SCSI. It's a High Density 50-pin
connector, right? from the front, same as everything else. Ah, I guess
you're thinking
in terms of a horizontal rack-mounted unit (the other one that
the
VAXes had was mounted like that); this unit has the extra pieces for
floor mounting and (AFAIK) doesn't have the brackets for rack mounting.
Does it make sense to have both the 70-32155-01 SCSI interface and the
HSD10-AA DSSI/SCSI unit in the same shelf?
1 x RZ29B 4.3GB
fast wide disk
RZ29B-VW? 1 x TLZ06 DDS
tape drive
You have an SBB, with a TLZ06 in it? Now I'm even greener with
envy! I've only got disks. Plus, I don't have any of the nice
enclosed models with doors.
I should have mentioned it's a BA35X-MD box.
These are actually the fans on the back of the shelf. The
good news is they're the good dual-speed ones that support
the 7200RPM drives. >It came wih a MicroVAX some time ago, but I've
never used it.
Anybody
want it, for a
suitably low price?
You might just want to keep it... I really like using StorageWorks
If you want, I should be able to dig up all the manuals on this, as I
think
I've got PDF's of them.
I'll have another look round, where it came from. They may still be
there.
--
Pete Peter Turnbull
Network Manager
University of York