Identification of EPROM Programming board - AIM or KIM or ???

To All, I just obtained a board which I think is an EPROM programming board for the AIM or KIM or ???, and I'm trying to find some information on it. It is not an RM65 board, the connector looks like it would plug right to an AIM. Here is a description: Measures 4-7/16 (4.4375)inches wide by 6-1/2 (6.5) inches long, including edge connector, lengthwise insertion. 44 pin gold plated edge connector with a 44 pin socket mounted immediately behind and parallel to the edge connector, on the component side of the PCB. 24 pin ZIF connector in the upper LH corner, viewing with the edge connector facing me (all descriptions below assume this position). 10 position DIP switch immediately to the right of the ZIF socket (no labeling), and another 10 position dip switch about halfway up the RHS, labeled 1 to 7 and B, C, D (probably address selection since one row of pins is all tied common and most of the pins on the other side of it go to a 74LS154). One LED, immediately to the right of the first 10 position DIP switch mentioned above, at the edge of the board. Two trimpots about center of the far edge of the board, to the right of the LED. Two jumper blocks, one with 2 pins, labeled W1, and one with 3 pins, labeled RO and RA. Two Toshiba 24 pin TMM2016P-1 RAMs left of center in second row of DIPs on the board. One 2516-45 EPROM to the left of the RAMS, with a label on top "6517A". On the solder side the only markings (in etch) are CUBIT INC, 1981 and the numbers 10362 and 6583. Most of the date codes on the ICs are between 8037 and 8203. There is no other model number, manufacturer, or other ID marking on this board. If anyone has any information on this board, please let me know (through the list). Thanks all, Bill whdawson(a)mlynk.com