At 04:46 PM 2/13/2014, Marc Howard wrote:
However (going from memory here) if I try:
.RUN SYS BUILD
$IN TC08
I get a message like (I think)
FILE NOT FOUND
I've tried all kinds of variations on this and I can't seem to install the
TC08 handler.
Could you tell me what I'm missing/doing wrong? The diagpack2.rk05 image
has TC08.SY and TC08.HN; isn't that what I need?
The convention on that pack is that a .SY file is a system handler and
a .HN file is a nonsystem handler.
You should be able to use
$ IN TC08.HN
Before you do this, use SET SYS NO INIT before you run BUILD since the
init command causes build to be overwritten in memory!
-rICK