A way to erase OTP components?

Bob Shannon wrote: A friend had a large quantity of programmed 27C512 OTP EPROMs, with contents of no use to him. He tried to erase them using a commerical X-ray machine, of the type used for inspecting assembled circuit boards (to check solder joints on BGA packages) and was unable to produce any noticable change to the part. This subject has been discussed on sci.electronics multiple times in the past, and the consensus was that the frequency of Xrays is such that they have no direct effect on the stored data. But at very high exposures it is definitely possible to damage the part. Note that the exposure levels used for baggage inspection at airports is far too low to cause any measurable effect on EPROMs. They are generally set to substantially lower levels than medical X-rays equipment. The normal erasure procedure for EPROMs is to use short-wave UV light, nominally at a wavelength of 2537 angstroms (about 254 nm). Unlike the more common long-wave UV (black lights), this *is* dangerous to your eyes; never look into the light. The light bulbs and the window on the EPROM are made from quartz rather than glass, because glass blocks most of the short-wave UV. Suitable bulbs are commonly sold for germicidal use. In the mid-1980s, at least one Japanese semiconductor company offered plastic windowed EPROMs. The package was a normal epoxy DIP package, except that a square area in the center was molded from a different plastic. The window was translucent (not transparent) to visible light. These were less expensive than the usual ceramic windowed parts, but more expensive than OTP parts. However, they could only be erased a small number of times because the plastic window becomes opaque to the shortwave UV with prolonged exposure. I'd heard of these plastic windowed packages at the time, but never actually saw one until I purchased a coin-op video game board at an auction. Eric