6 Dec
2021
6 Dec
'21
4:44 p.m.
On 12/6/21 17:45, Mike Katz wrote:
If I may8 ask a question.? I have never had boards
made before. How do
I find a good board house that is reasonable and how do I specify the
board especially for the PDP-8 Omnibus which should have gold fingers
on the edge connectors?
I was planning to try PCBWay for my boards. They say they do hard gold
fingers and they have a board assembly option that looks like it can do
what I need. I haven't used them before so this will be an experiment in
that direction as well.
If you're using KiCad for your designs (and if the Omnibus uses the
standard DEC boards), I have templates for double and quad height?
boards that you're welcome to. Since I haven't yet made boards from
them, check yourself that they're right before ordering but at least
they'd be a start.
Dave