19 Oct
2010
19 Oct
'10
3:20 a.m.
As far as I can tell, I only have a terminator module (behind slot 6), but
not a jumper module.
Regards
Rob
-----Original Message-----
From: cctalk-bounces at classiccmp.org [mailto:cctalk-
bounces at classiccmp.org] On Behalf Of Adrian Graham
Sent: 19 October 2010 10:24
To: General Discussion: On-Topic and Off-Topic Posts
Subject: Re: More SCSI Confusion
On 19 October 2010 00:13, Rob Jarratt <robert.jarratt at ntlworld.com> wrote:
That should be under the other fan, you normally just swap them over top
to
Rob
I have confirmed that it is indeed working in split bus mode. It seems
I need a BA35X-MF jumper module to get it to work in single bus mode.
bottom. If you look in the front of the enclosure
you'll see a pin poking
through near the top and bottom, I think they're marked 'T'
and 'J'. This shows you which is currently the jumper and which is the
terminator.
--
adrian/witchy
Owner of Binary Dinosaurs, the UK's biggest home computer collection?
www.binarydinosaurs.co.uk