test-drb

test-drb@ccmp.vtda.org

101090 discussions

by edick＠idcomm.com

A friend of mine and I had about a dozen of those SMO-501's back in about '89 or '90. We cleaned and upgraded them. Their performance on a PC of that era was comparable to the previous generation of PC-based SCSI hard disks. It was not impressive, but it wasn't terribly slow. We had so much trouble keeping them at $1k each that I never used one myself at all. They were just too valuable to keep. From what I remember, their performance was more or less comparable to my Iomega 8" Bernoulli Boxes, though they were MUCH larger in capacity. Dick -----Original Message----- From: Joe <rigdonj(a)intellistar.net> To: classiccmp(a)classiccmp.org <classiccmp(a)classiccmp.org> Date: Thursday, February 17, 2000 9:53 AM Subject: Re: WTB: 5 1/4" Magneto Optical Cartridges >Jerome, > > What are you going to use the MO drive on? Just curious. I have a >SMO-501 also. It's SLOW!! The transfer rate and access time are WORSE than >a floppy drive. > > Joe > >At 03:10 PM 2/16/00 -0500, you wrote: >>I am looking for a source for the 600 Mbyte magneto optical >>5 1/4" cartridges with 512 byte per sector. Tim Shoppa >>has mentioned in the past that he might know where I can >>find some. Does anyone else? These will be used in a >>SONY SMO S-501 5 1/4" magneto optical disk drive. >> >>I have checked eBay, but they are usually sold as is? >> >>Sincerely yours, >> >>Jerome Fine >> >> >

26 years, 2 months

WTB: 5 1/4" Magneto Optical Cartridges

by jhfine＠idirect.com

I am looking for a source for the 600 Mbyte magneto optical 5 1/4" cartridges with 512 byte per sector. Tim Shoppa has mentioned in the past that he might know where I can find some. Does anyone else? These will be used in a SONY SMO S-501 5 1/4" magneto optical disk drive. I have checked eBay, but they are usually sold as is? Sincerely yours, Jerome Fine

26 years, 2 months

Send/Receive (BAUDOT) in GWBASIC (was Ham Stats)

by kees.stravers＠iae.nl

On 2000-02-16 classiccmp(a)classiccmp.org said to kees.stravers(a)iae.nl cl>Hi Gang: cl>Further to this discussion of 5 bit characters on a DL11, this was cl>also possible on the PCjr. I wrote a BASIC send/receive RTTY cl>program for the PCjr in 1985. It used an esoteric mode of the cl>particular serial chip on the PCjr, to support 5 data bits and 1.5 cl>stop bits. The DTR pin of the serial port was used to toggle the cl>radio from transmit to receive. My modem was homebrew, built around cl>an XR2211 (IIRC) chip. I still have the modem buried in the cl>crawlspace somewhere. This was also possible with the serial port of a regular PC. I have been running a RTTY BBS on 144 MHz for 10 years, based on a TRS-80 Model I program I ported to the PC and extended. My program even had an interface to the nearest packet radio BBS, so RTTY users could exchange mail with packet users, and later the system could also communicate in CW (morse code) so you could send emails without having a computer. But nobody uses RTTY anymore, and even CW is on the decline, so I have taken the BBS down, no more users. Kees -- Kees Stravers - Geldrop, The Netherlands - kees.stravers(a)iae.nl http://www.iae.nl/users/pb0aia/ My home page http://www.vaxarchive.org/ Info on old DEC VAX computers Net-Tamer V 1.08.1 - Registered

26 years, 2 months

virtual hamfest was Re: couple of books, spring cleaning

by wrm＠ccii.co.za

Ack! I said: >dahdidit dit dahdahdidah dididit didahdahdahdah dahdidah dit >didahdidahdit dahdidah. And of course it should be dahdahdidit dididit, d?mmit! Shows you how long ago I've played with my radios! Wouter "Where's QS1 anyway" ZS1KE

26 years, 2 months

Ham population stats

by ethan_dicks＠yahoo.com

--- John Wilson <wilson(a)dbit.dbit.com> wrote: > On Wed, Feb 16, 2000 at 06:44:14PM +0000, Tony Duell wrote: > > Hmmm.. I've tried to learn morse several times, and failed every single > > time. I don't know why, but it just doesn't seem to 'click' with me. > > Well, having an actual use for it makes it a lot easier to remember. My > best friend and I learned Morse code in 6th grade so that we could pass > notes in class that no one could understand. Naturally that later fizzled, > the 7th grade teacher was a ham and the 8th grade teacher was a radio > operator in the Norwegian underground in WW2, so much for that idea! My younger brother did that as a kid, too. The teacher tapped back "cut it out" when they tried it during a test. > I *always* wanted to do that, I actually bought a DUP11 years ago for this > purpose but never dug up documentation on it until recently. You'd need to > build some kind of external clock (PLL really I guess) that synchronized to > the bit transitions of AX.25, shouldn't be a very big deal though. My knowledge of sync serial comes from years of working with third party devices on DEC equipment, but here goes... If the DUP-11 has a COM5025 serial chip on it then what it's expecting is something like a "standard" bit-rate on its input connector. With the right cable, I'd expect to feed it clocking through pins 15 and 17 on a DB-25 at EIA levels (+/- 12VDC). We used to have racks of "modem eliminators" that were effectively null-modem devices that would provide clocks to DTE equipment on both sides. There were typically various options to set as well, bit rate being chief among them. Most of ours were set to between 9600 and 56Kbps with a couple set to 64kpbs and one to 128kbps for reproducing environments of our European customers. Sync serial has no start bits, no stop bits, just bits. With protocols like SDLC, there's a "flag byte" of 0x7E (0111 1110) that the receiving hardware uses to determine the start and stop of a packet. One efficiency of sync hardware is you aren't trasmitting 10 bits to communicate 8. The downside is extra hardware on both ends and slightly more expensive cables to send it all. If I'm confusing the DUP-11 with other DEC cards that use the COM5025, sorry. The original Software Results Corp. COMBOARD used that chip because it was identical to whatever Qbus card we used to use when we were shipping the HASPBOX (a PDP-11 with sync serial and a DPV-11 to communicate via parallel to a PDP-11/70 or VAX-11/7xx). > Stupid question: what comes out of the other side of a ham TNC these days? > It used to be Bell 202 modem tones at 1200 baud HDX, over an FM voice signal, > it *can't* still be that easy though can it? In the 2 meter band in the U.S., at least, Hams are restricted to 1200 baud. AFAIK, it is that simple. There are "pocket TNCs" that are little more than audio modulator circuits that depend on the CPU in your PeeCee to produce a valid AX.25 bitstream. I've seen it work with an HP-95LX - "pocket packet". -ethan ===== Infinet has been sold. The domain is going away in February. Please send all replies to erd(a)iname.com __________________________________________________ Do You Yahoo!? Talk to your friends online with Yahoo! Messenger. http://im.yahoo.com

26 years, 2 months

FW: DigiData 9-tracker, I/F, and software for sale

by kyrrin＠bluefeathertech.com

Found this fellow advertising in a ham radio group. I've given him some correction on that, and offered to forward what he has to the list. I'm no DigiData expert, but he tells me that the driver software that comes with the drive is DOS-based. This tells me it's either SCSI or Pertec (SCSI most likely), and decent SCSI 9-trackers are rare. He's in Durham, NC, and I doubt he'd be looking for a mint on this thing. Whoever wants a crack at this, please contact him directly. -=-=- <break> -=-=- >>For Sale, best offer: >> >>9-track tape drive, rack-mount >>Digidata Corp, model 1749-86-4-120-FD-UL >>w/ software, 8-10"reels, 6-8" reels >>in good working condition "Chris Slacke" <drivetime(a)mindspring.com> -=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=- Bruce Lane, Owner and head honcho, Blue Feather Technologies http://www.bluefeathertech.com // E-mail: kyrrin(a)bluefeathertech.com Amateur Radio: WD6EOS since Dec. '77 "Our science can only describe an object, event, or living thing in our own human terms. It cannot, in any way, define any of them..."

26 years, 2 months

Source code for BASIC

by paulrsm＠ameritech.net

The Merlin assembler for the Apple II came with a demo program that would disassemble the Applesoft BASIC ROMs, with comments. I can provide this disassembly to you. I think Microsoft sold their 6502 BASIC to Commodore, complete with source code. Commodore was then able to change the code as needed for their various 6502 computers. ---------- > From: Richard A. Cini, Jr. <rcini(a)msn.com> > To: ClassCompList <classiccmp(a)classiccmp.org> > Subject: Source code for BASIC > Date: Tuesday, February 15, 2000 08:42 PM > > Here's another question...does anyone have a pointer to the source code for > a 6502-based BASIC interpreter that's ROMable?

26 years, 2 months

WTB: 5 1/4" Magneto Optical Cartridges

by xds_sigma7＠hotmail.com

Jerome, Well if you need 1.3 GB ones, I have 90-something, mostly used but a few are new... all are rewriteable MO disks, all are HP Will J ______________________________________________________ Get Your Private, Free Email at http://www.hotmail.com

26 years, 2 months

Ham population stats

by ethan_dicks＠yahoo.com

--- "Shawn T. Rutledge" <rutledge(a)cx47646-a.phnx1.az.home.com> wrote: > On Wed, Feb 16, 2000 at 04:31:51PM -0800, Ethan Dicks wrote: > > In the 2 meter band in the U.S., at least, Hams are restricted to 1200 > baud. > > No, not exactly. But we are limited to the same bandwidth as an FM > voice channel, so there is a practical limit. 9600 baud fits into the > permissible deviation well enough and is commonly used on 2 meters. I guess things changed when I wasn't looking. Thanks for the update. -ethan ===== Infinet has been sold. The domain is going away in February. Please send all replies to erd(a)iname.com __________________________________________________ Do You Yahoo!? Talk to your friends online with Yahoo! Messenger. http://im.yahoo.com

26 years, 2 months

Macintosh Portable problems

by netsurfer_x1＠hotmail.com

Finally got my Mac Portable battery rebuilt, the thing runs great! But I think I have a problem. Whenever I check the "Battery" DA or the battery gauge on the menu bar, the batteries never seem to be charged up more than half way. Anybody got any ideas? ____________________________________________________________ David Vohs, Digital Archaeologist & Computer Historian. Computer Collection: "Triumph": Commodore 64C, 1802, Double FDD, GeoRam 512, Okimate 20. "Leela": Macintosh 128 (Plus upgrade), Nova SCSI HDD, Imagewriter II. "Delorean": TI-99/4A. "Monolith": Apple Macintosh Portable. ____________________________________________________________ ______________________________________________________ Get Your Private, Free Email at http://www.hotmail.com

26 years, 2 months

Jump to page:

2026

2025

2024

2023

2022

2021

2020

2019

2018

2017

2016

2015

2014

2013

2012

2011

2010

2009

2008

2007

2006

2005

2004

2003

2002

2001

2000

1999

1998

1997

test-drb