Programming Bipolar PROMs (Tom Hunter)

[Holm Tiffe]

Mark Moulding via cctalk wrote:

> From: Tom Hunter <ccth6600 at gmail.com>
> Subject: Programming Bipolar PROMs
> 
> > The part is an Intersil IM5600CP, but these were also made by others, for
> > example Signetics and Philips made the 82S23 and TI and NTE made the 
> > faster
> > SN74S188N. Some vendors still sell these parts and there are even a few on
> > Ebay.
> >
> > How do I program these PROMs? I found one somewhat obscure description of
> > the algorithm in the NTE datasheet, but I suspect that each manufacturer
> > had (somewhat) different algorithms.
> 
> I built a project using Russian clones of the 74188, and ended up building a 
> programmer for them.  The programming process is slow (over a minute to 
> program 32 bytes), draws quite a bit of power (the chip is uncomfortably 
> warm afterwards), and it took a while to work out the programming algorithm. 
> Also, as Tom Hunter mentioned, the programming process isn't perfect - about 
> 5% don't program correctly; I don't know if this is my algorithm or the fact 
> that the clones aren't so good.  However, once programmed, they seem to work 
> just fine.


K155RE3? (К155РЕ3)

I've had to repair a stepper motor controller from some CNC grinding
machine lately. Luckily I had 2 such controllers, one with a working ROM
(some TIBPxxx) and I had K155RE3 in a box. I've programmed it with an
Labtool48 using Dataman48 Software on Windows. The Dataman ist the same
thing as the Labtool. It programmed the ROMs successfully as 74S188,
but the first peace failed to program correctly. Programming was
relatively fast, below 2 seconds with verify.

Regards,
-- 
       Technik Service u. Handel Tiffe, www.tsht.de, Holm Tiffe, 
         Goethestrasse 15, 09569 Oederan, USt-Id: DE253710583
info at tsht.de Fax +49 37292 709779 Tel +49 37292 709778 Mobil: 0172 8790 741