In the vid that I've linked you can see two decatrons already doing
this (pretty much at the end).
Currently they divide the grid frequency of 50Hz with 50, one 1:10
and the other 1:5 (two opposite kathodes paralleled).
So yes I can, but my problem is'nt how to divide the xtal frequency, it
is to generate a stable one.
There are several possibilities to divide the frequency, binary with
flipflops, with ring counters (every possible factor as long as it is
an integer) or even with monoflops.
Regards,
Holm
Anders Nelson via cctalk wrote:
Can you use decatrons? Each will divide by a power of
ten.
--
Anders Nelson
On Mon, Nov 16, 2026, 8:43 AM Will Cooke via cctalk <cctalk(a)classiccmp.org>
wrote:
>
>
> > On 11/16/2026 8:08 AM EST Holm Tiffe via cctalk <cctalk(a)classiccmp.org>
> wrote:
> >
> >
> > Hi all,
> ...
> >
> > So here my question: Has anyone an xtal with an very low frequency laying
> > around, which frequency can be devided down to 1 Hz (with ring counters,
> > flipflops etc)? Maybe 1 oder 2Khz? ..or some other frequency that is
> > "dividable" to 1Hz?
> > Shouldn't be for nothing and I'm paying for the shipping (to germany).
> >
> > This is not the last stand, but it can demonstrate what I'm doing:
> >
> >
https://www.tiffe.de/images/uhr2.mp4
> >
> > Thx in advance,
> > Holm
> > --
>
>
> Hi,
> That's a really cool project. You obviously have more patience than I. I
> would like to see the final result.
>
> I've personally never seen a crystal lower than 10 KHz. I didn't know
> such a thing existed. However, have you considered making your own? I
> have heard of that being done and have wanted to try it, but I haven't
> gotten around to it yet. In theory it should be relatively easy. Take a
> chunk of quartz, cut it into a rectangle, and attach electrodes. Grind on
> sandpaper and a flat surface until you get the right frequency. Of course,
> once you cut the crystal you can only raise the frequency. "Crystal
> grinding" to raise the frequency used to be a common practice. I am not
> sure about starting from scratch. I have seen very little of that. But it
> might be worth trying if you the project hasn't already used up all your
> patience!
>
> Good luck!
> Will
>
--
Technik Service u. Handel Tiffe,
www.tsht.de, Holm Tiffe,
Goethestrasse 15, 09569 Oederan, USt-Id: DE253710583
info(a)tsht.de Tel +49 37292 709778 Mobil: 0172 8790 741