My first thought was to use a 555 timer as well, but I think the ask was to
use no ICs. In any case, all digital logic was first created without ICs.
--
Anders Nelson
On Mon, Nov 16, 2026, 10:12 AM <bitwiz(a)12bitsbest.com> wrote:
Is there any reason you can't either use a 555 or
use a higher frequency
crystal and decade counters to divide or a small micro with a programable
timer (pico, nxp, altera, etc.)
On Nov 16, 2026 8:21 AM, Anders Nelson via cctalk <cctalk(a)classiccmp.org>
wrote:
Can you use decatrons? Each will divide by a power of ten.
--
Anders Nelson
On Mon, Nov 16, 2026, 8:43 AM Will Cooke via cctalk <cctalk(a)classiccmp.org>
wrote:
> On 11/16/2026 8:08 AM EST Holm Tiffe via cctalk <cctalk(a)classiccmp.org>
wrote:
Hi all,
...
>
> So here my question: Has anyone an xtal with an very low frequency
laying
> around, which frequency can be devided down
to 1 Hz (with ring
counters,
flipflops
etc)? Maybe 1 oder 2Khz? ..or some other frequency that is
"dividable" to 1Hz?
Shouldn't be for nothing and I'm paying for the shipping (to germany).
This is not the last stand, but it can demonstrate what I'm doing:
https://www.tiffe.de/images/uhr2.mp4
Thx in advance,
Holm
--
Hi,
That's a really cool project. You obviously have more patience than I.
I
would like to see the final result.
I've personally never seen a crystal lower than 10 KHz. I didn't know
such a thing existed. However, have you considered making your own? I
have heard of that being done and have wanted to try it, but I haven't
gotten around to it yet. In theory it should be relatively easy. Take
a
chunk of quartz, cut it into a rectangle, and
attach electrodes. Grind
on
sandpaper and a flat surface until you get the
right frequency. Of
course,
once you cut the crystal you can only raise the
frequency. "Crystal
grinding" to raise the frequency used to be a common practice. I am not
sure about starting from scratch. I have seen very little of that. But
it
might be worth trying if you the project
hasn't already used up all your
patience!
Good luck!
Will