15 Mar
2023
15 Mar
'23
9:26 a.m.
On Wed, Mar 15, 2023 at 11:48 AM Jon Elson via cctalk <cctalk(a)classiccmp.org>
wrote:
On 3/14/23 22:55, Bill Degnan via cctalk wrote:
I spent time with the drive, I could not find a clamp or screw that was
holding the drive closed, I had never seen that found in a Persci drive
before, but
I guess that's the problem, bad motor holding it closed. Kinda weird but I
can work from there.
BIll
I am working on an unknown status Persci 299
drive and one of the two
drives is locked closed. Is this a "park" of some kind or is the drive
broken? If it's a parked drive (only the drive 0 side) how do you unpark
the drive? I can't seem to find any info on this. If I find anything I
will post my findings.
This is a dual 8" floppy drive with linear voice coil head
positioning? I used to have one of those.
There are two 12V (I think) gear motors that operate the hub
clamp arm. The logic is very simple, press the button on
the front, the motor should unclamp the hub, press a disk in
the slot, the motor will clamp the hub. Check the switch in
the floppy slot to see if it thinks the floppy is in. But,
it seems anyway that the button has to take precedence over
the floppy in sensor. One possibility is that the motor has
failed, you can unplug the motor and apply 12 V to it and
see if it moves. Otherwise, the full-bridge driver has gone
bad. Or, mayvbe just a bad connection where the motor plugs
into the board.
Jon