The favourite crystal supplier to radio amateurs hereabouts is Krystaly
(
www.krystaly.cz). The seem to be able to sort you out with just about
anything.
Regards, Frank.
On 16/11/2026 15:16, Anders Nelson via cctalk wrote:
> My first thought was to use a 555 timer as well, but I think the ask was to
> use no ICs. In any case, all digital logic was first created without ICs.
>
> --
> Anders Nelson
>
> On Mon, Nov 16, 2026, 10:12 AM<bitwiz(a)12bitsbest.com> wrote:
>
>> Is there any reason you can't either use a 555 or use a higher frequency
>> crystal and decade counters to divide or a small micro with a programable
>> timer (pico, nxp, altera, etc.)
>>
>> On Nov 16, 2026 8:21 AM, Anders Nelson via cctalk<cctalk(a)classiccmp.org>
>> wrote:
>>
>> Can you use decatrons? Each will divide by a power of ten.
>>
>> --
>> Anders Nelson
>>
>>
>>
>> On Mon, Nov 16, 2026, 8:43 AM Will Cooke via cctalk<cctalk(a)classiccmp.org>
>>
>> wrote:
>>
>>>
>>>> On 11/16/2026 8:08 AM EST Holm Tiffe via
cctalk<cctalk(a)classiccmp.org>
>>> wrote:
>>>>
>>>> Hi all,
>>> ...
>>>> So here my question: Has anyone an xtal with an very low frequency
>> laying
>>>> around, which frequency can be devided down to 1 Hz (with ring
>> counters,
>>>> flipflops etc)? Maybe 1 oder 2Khz? ..or some other frequency that is
>>>> "dividable" to 1Hz?
>>>> Shouldn't be for nothing and I'm paying for the shipping (to
germany).
>>>>
>>>> This is not the last stand, but it can demonstrate what I'm doing:
>>>>
>>>>
https://www.tiffe.de/images/uhr2.mp4
>>>>
>>>> Thx in advance,
>>>> Holm
>>>> --
>>>
>>> Hi,
>>> That's a really cool project. You obviously have more patience than I.
>> I
>>> would like to see the final result.
>>>
>>> I've personally never seen a crystal lower than 10 KHz. I didn't
know
>>> such a thing existed. However, have you considered making your own? I
>>> have heard of that being done and have wanted to try it, but I haven't
>>> gotten around to it yet. In theory it should be relatively easy. Take
>> a
>>> chunk of quartz, cut it into a rectangle, and attach electrodes. Grind
>> on
>>> sandpaper and a flat surface until you get the right frequency. Of
>> course,
>>> once you cut the crystal you can only raise the frequency. "Crystal
>>> grinding" to raise the frequency used to be a common practice. I am not
>>> sure about starting from scratch. I have seen very little of that. But
>> it
>>> might be worth trying if you the project hasn't already used up all your
>>> patience!
>>>
>>> Good luck!
>>> Will
>>>
>>
>>