AW: 50Hz Pulley for 8" Floppy Drive Mitshubishi M2894-63B

[Guy Dunphy]

Ok. Those are quite small. So you have one? Or those are not yours?
If you have one, and a way to accurately measure it, making more will be easy for anyone with a lathe.
I could do it, but surely you can find a machinist closer to home?

Guy

At 01:03 PM 10/11/2018 +0000, Riesen Thomas wrote:
>Guy,
>I am looking for small motor pulley ... see pic ...
>Regards
>Thomas
>
>-----Ursprüngliche Nachricht-----
>Von: Guy Dunphy [mailto:guykd at optusnet.com.au] 
>Gesendet: Samstag, 10. November 2018 13:25
>An: Riesen Thomas <thomas.riesen at predata.ch>; General Discussion: On-Topic and Off-Topic Posts <cctalk at classiccmp.org>
>Betreff: Re: 50Hz Pulley for 8" Floppy Drive Mitshubishi M2894-63B
>
>At 12:03 PM 10/11/2018 +0000, you wrote:
>>Hi all
>>
>>Any suggestions where to find two 50Hz-Pulleys for the 8" Floppy drive 
>>Mitsubishi M2894-63B?
>>
>>If there also the appropriate ribbon gummies available, I would be very 
>>happy.
>>
>>Regards
>>Thomas
>
>
>Do you know what they look like, and the dimensions?
>Because I have these. http://everist.org/pics/misc/IMG_1655_pulley_800.jpg
>
>_Maybe_ they were off Mitsubishi drives, not sure. Had them in a box of floppy drive related bits for a loooong time, and have no recollection of where they came from. 
>These are 49.0 mm OD, hole 4.7 mm dia. And this is Australia, with 50Hz mains.
>
>Guy
>
>
>Attachment Converted: "f:\email\attach\Pully_8Zoll_02.jpg"
>
>Attachment Converted: "f:\email\attach\Pully_8Zoll_01.jpg"
>