Q: Plotter bed repair with MonoKote?

dwight dkelvey at hotmail.com
Mon Feb 18 22:00:53 CST 2019


I find that it is too much pre-stretched I carefully remove some of the stretch with a heat gun and a frame to hold it. You'd need to experiment some. It has to have a little stretch left to shrink.
Dwight

________________________________
From: cctech <cctech-bounces at classiccmp.org> on behalf of David Collins via cctech <cctech at classiccmp.org>
Sent: Monday, February 18, 2019 2:15 PM
To: Craig Ruff; General Discussion: On-Topic Posts
Subject: Re: Q: Plotter bed repair with MonoKote?

Also very interested in the use of Monokote to repair plotter beds...any more info/experience/tips/traps would be much appreciated.

David Collins
HP Computer Museum

> On 19 Feb 2019, at 5:37 am, Craig Ruff via cctech <cctech at classiccmp.org> wrote:
>
>
>> On Feb 18, 2019, at 11:00 AM, dwight wrote:
>>
>> There were a couple hp XY plotters that had the mylar plate delaminating. I've reworked these with model airplane mono coat.
>
> Are you referring to MonoKote (<http://>www.monokote.com <http://www.monokote.com/>)?  That looks perfect for repairing the gouged bed of one of my 9872C plotters.  Is a hot air supply suitable for applying the film, or did you use their heating iron?  I'm guessing a bit of pressure to adhere the film is necessary?


More information about the cctalk mailing list