21 Nov
2025
21 Nov
'25
10:19 a.m.
Mike,
Which connectors is it you need?
-Peter
On Fri, Nov 21, 2025 at 1:08 PM Mike Katz via cctalk <cctalk(a)classiccmp.org>
wrote:
Paul,
The connectors are about $5 apiece and I would need 7 connectors. I
have the cable and tool.
My goal for asking was to see if anyone had a spare cable or two and
save them from eventually going in the land fill.
Thank you for your help,
Mike
On 11/21/2025 11:17 AM, Paul Koning via cctalk wrote:
For that matter, since the connectors are
insulation displacement type,
you can assemble your own: buy the connectors and a length of table, cut
pieces to size, and assemble the connectors onto the cable. A press is
normally used for that, but a vise should do the job too.
paul
> On Nov 21, 2025, at 11:03 AM, Paul Koning via cctalk <
cctalk(a)classiccmp.org> wrote:
>
> General comment on cables like that: in the past I have obtained flat
ribbon cable assemblies from Digikey. If you're dealing with a cable
that's simply a ribbon of width N and a connector at each end, companies
like that can supply them easily and cheaply, in any length you want.
>
> paul
>
>> On Nov 20, 2025, at 9:40 PM, Mike Katz via cctalk <
cctalk(a)classiccmp.org> wrote:
>>
>> Does anyone out there have a spare 1/2 high 5 1/4" Seagate MFM hard
drive face plate (ST-221, ST-251, etc.) that they can let go cheap?
>>
>> And also a 34 conductor dual drive cable and a single 20 on single
drive cable?
>>
>> Thank you.
>>
>> Contact me off list at bitwiz(a)12bitsbest.com