8 Feb
2024
8 Feb
'24
4:15 p.m.
I have a Qualstar 3412 that I've used with Depot4. I last used this on a
386 running DOS 6.22, a Trantor SCSI card and SCSIWorks! as the ASPI
driver.
Travis
On Thu, Feb 8, 2024 at 12:14 AM Nico de Jong via cctalk <
cctalk(a)classiccmp.org> wrote:
> Based on the comment in a message posted last
fall, I downloaded and
> installed the Overland Data Depot4 software that was mentioned during
> a discussion of SCSI tape tools. But so far I've been stumped in
> getting it to work. Basic system is a freshly set up Win98SE and an
> Adaptec 1522 SCSI board connected to a Qualstar 9track. Depot4
> installs and runs without issue but when I try to point it at the
> ASPI drivers it fails to recognize anything. Any suggestions on
> where to look or what to tweak would be seriously appreciated!
The 34xx series has a SCSI - Pertec interface, so if you remove this
board, you have a Pertec drive.
Thanks'
Nico