hp 9145 capstan replacement

Plamen Mihaylov plamenspam at afterpeople.com
Sun Apr 25 06:18:36 CDT 2021


I have it fixed with this tube:

https://www.aquatuning.no/vannkjoeling/slanger/tubes/2265/masterkleer-tubing-pvc-17-4/13mm-1/2-id-clear

Best regards,
Plamen

On Saturday, April 24, 2021, Kurt Nowak via cctalk <cctalk at classiccmp.org>
wrote:

> I was going to mention him too but you beat me to it. He does really great
> nice work. I've had a few QIC drive rollers replaced through him.
>
> http://www.terrysrubberrollers.com/
>
> -Kurt
>
> On Fri, Apr 23, 2021, 20:32 Chuck Guzis via cctalk <cctalk at classiccmp.org>
> wrote:
>
> > On 4/23/21 8:11 PM, Curious Marc via cctalk wrote:
> > > I tired several methods which worked to some extent (afore mentioned
> > silicone tubes, shrink wrap, eBay bought molded rubber  overwraps,
> machined
> > grooves and add O-rings), but now I just strip my capstans clean and coat
> > them with plasti-dip. Methods in shown my various videos (like here
> > https://youtu.be/cTZCD4OXETk ). Only plastidip and o-rings have been
> > durable enough in the long run, and plasti-dip is easier. I have not
> done a
> > capstan this large though. There are also some folks out there that will
> > also commercially recoat a capstan with correctly molded and vulcanized
> > rubber.
> > > Marc
> >
> > In the past, I've used this guy:
> >
> > http://www.terrysrubberrollers.com/
> >
> > Top-notch work.
> >
> > --Chuck
> >
> >
>


More information about the cctech mailing list