hp 9145 capstan replacement

Kurt Nowak knowak at alumni.calpoly.edu
Sat Apr 24 02:40:11 CDT 2021


I was going to mention him too but you beat me to it. He does really great
nice work. I've had a few QIC drive rollers replaced through him.

http://www.terrysrubberrollers.com/

-Kurt

On Fri, Apr 23, 2021, 20:32 Chuck Guzis via cctalk <cctalk at classiccmp.org>
wrote:

> On 4/23/21 8:11 PM, Curious Marc via cctalk wrote:
> > I tired several methods which worked to some extent (afore mentioned
> silicone tubes, shrink wrap, eBay bought molded rubber  overwraps, machined
> grooves and add O-rings), but now I just strip my capstans clean and coat
> them with plasti-dip. Methods in shown my various videos (like here
> https://youtu.be/cTZCD4OXETk ). Only plastidip and o-rings have been
> durable enough in the long run, and plasti-dip is easier. I have not done a
> capstan this large though. There are also some folks out there that will
> also commercially recoat a capstan with correctly molded and vulcanized
> rubber.
> > Marc
>
> In the past, I've used this guy:
>
> http://www.terrysrubberrollers.com/
>
> Top-notch work.
>
> --Chuck
>
>


More information about the cctech mailing list