PDP-11 RL02 disk emulation

[Doug Jackson]

My 11/34 and 11/10 would be very happy to have one of these each .

Doug Jackson 

On 25 October 2016 5:28:05 am AEDT, Scott Baker <scott.l.baker at gmail.com> wrote:
>Hi Noel,
>
>>> Any chance it could be put into 'production'?
>Sure, if there is interest, I could make a run of boards.
>
>>> Also, what FPGA board are you using? I assume it's one that has an
>SD
>>> card socket or something, for actually storing the bits on?
>
>My project is just an interface board for an existing RL02 emulator
>project: www.pdp11gy.com  There are a multiple project revisions listed
>on
>the pdp11gy.com site that use different Altera FPGA dev boards: DE0
>Nano,
>DE0 Nano SOC, and BeMicro CV.
>
>I was planning to use a Terasic DE0 Nano dev board since these boards
>can
>be found on eBay from $50 to $100. The DE0 nano does not have an
>micro-SD
>card socket which is why there is a socket on my interface board.
>http://sierracircuitdesign.ddns.net/temp/RL02
>
>The DE0 Nano SOC, and BeMicro CV dev boards have micro-SD card sockets,
>so
>if you used one of those, then you would not need to populate the
>micro-SD
>socket on the interface board. According to the author of the
>www.pdp11gy.com RL02 project, the 40-pin headers on DE0 Nano, DE0 Nano
>SOC,
>and BeMicro CV are compatible, so you could use my interface board with
>any
>of these boards.
>
>Regards,
>Scott

-- 
Sent from my Android device with K-9 Mail. Please excuse my brevity.