H960 blank panel clips

[Vincent Slyngstad]

From: Charles Dickman: Tuesday, July 28, 2015 9:03 AM
> If the posts and balls are metal, the panel sockets are going to crack
> because there will not be any give in the shaft. If the ball and shaft
> is replaced with a solid pin, the panel sockets will get damaged
> because the socket will have to flex to conform to the pin.

What he said :-).

> I like the idea of an X cut in the ball.

What do folks think of the idea of thickening the shaft, 
terminating it in a hemisphere, but then cutting half-way 
down the result with a Y or X shaped cut?  The cut would 
hopefully allow the result to flex and taper into the socket,
providing plenty of grip without actually tearing anything 
up.

    Vince