RK11-C indicator panel inlays?

[Mike Katz]

I am currently using kicad for the stuff from other PDP-8/omnibus 
creators but I intensely dislike the user interface paradigm on kicad.

We use Altium at work and I have been thinking about using that.

On 12/6/2021 6:44 PM, David Bridgham via cctalk wrote:
> On 12/6/21 17:45, Mike Katz wrote:
>
>> If I may8 ask a question.  I have never had boards made before. How 
>> do I find a good board house that is reasonable and how do I specify 
>> the board especially for the PDP-8 Omnibus which should have gold 
>> fingers on the edge connectors?
>
>
> I was planning to try PCBWay for my boards. They say they do hard gold 
> fingers and they have a board assembly option that looks like it can 
> do what I need. I haven't used them before so this will be an 
> experiment in that direction as well.
>
> If you're using KiCad for your designs (and if the Omnibus uses the 
> standard DEC boards), I have templates for double and quad height  
> boards that you're welcome to. Since I haven't yet made boards from 
> them, check yourself that they're right before ordering but at least 
> they'd be a start.
>
> Dave
>