non-shunting jumpers?

[Maciej W. Rozycki]

On Thu, 22 Oct 2020, Chuck Guzis via cctalk wrote:

> > A variation on the connector idea: use an insulation-displacement type 
> > connector (the kind that you mount onto a flat cable assembly) without 
> > the cable.  Just snap on the cover over the i-d pins and you have a 
> > fully insulated assembly with the pins acting as spring clamps for the 
> > jumper pins.
> 
> That's not terribly useful when you have only one or two positions to
> protect, is it?

 Following the idea however you can use a wire-to-board connector housing 
like from Harwin M20 series with just empty contacts inserted.  They are 
widely available and start from 1x1 even.

<https://www.harwin.com/connectors-hardware/pcb-connectors/2-54mm-pitch-pcb-connectors/>

  Maciej