RE: Re: 34 pin Card Edge “Male to Male” Connector

[William Sudbrink]

I'm not sure you're quite getting it... they say a picture is worth a thousand words:

http://wsudbrink.dyndns.org:8080/images/20181128_194316.jpg

Assuming I make up some gerbers myself, two questions:

1) how do you specify the slightly beveled edge required for easy insertion?
2) is there some way to specify "hardened" or whatever plating for the connector traces?

And actually a third: Does anyone have a particular PCB company that they like, communications wise?

Bill S.



---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus