TU58 yet one more time.

[Paul Birkel]

-----Original Message-----
From: cctalk [mailto:cctalk-bounces at classiccmp.org] On Behalf Of Al Kossow
Sent: Sunday, May 29, 2016 3:00 PM
To: cctalk at classiccmp.org
Subject: Re: TU58 yet one more time.

On 5/29/16 11:34 AM, Mark J. Blair wrote:
> My first attempt to use silicone tubing to repair my TU58 rollers was also
unsuccessful. Maybe the material I used is too soft? Your experience
suggests to me that I should hook up an oscilloscope to measure bit timing,
and then adjust the roller composition and diameter to arrive close to the
correct bit length.
> 
> 

dug this up from the cctlk archive


--

http://www.usplastic.com/catalog/item.aspx?itemid=23485
It just says "norprene A-60-F" the outside.  It measures 3/8" I.D.

I think other's have said 7/16" i.d., but I could not find that.  I know I
bought it from US Plastics and it's A-60-F.
You have to buy 10' but its not very expensive.

-brad

-----

"A-60-F" would be here?
http://www.usplastic.com/catalog/item.aspx?itemid=23886  $26.95 for 10 foot
length.  Ouch!

3/8" ID x 5/8" OD x 1/8" Wall TygonR A-60-F Hot Food & Beverage Tubing

-----