TU58 yet one more time.

[Al Kossow]

On 5/29/16 11:34 AM, Mark J. Blair wrote:
> My first attempt to use silicone tubing to repair my TU58 rollers was also unsuccessful. Maybe the material I used is too soft? Your experience suggests to me that I should hook up an oscilloscope to measure bit timing, and then adjust the roller composition and diameter to arrive close to the correct bit length.
> 
> 

dug this up from the cctlk archive


--

http://www.usplastic.com/catalog/item.aspx?itemid=23485
It just says "norprene A-60-F" the outside.  It measures 3/8" I.D.

I think other's have said 7/16" i.d., but I could not find that.  I know I bought it from US Plastics and it's A-60-F.
You have to buy 10' but its not very expensive.

-brad