PDP 8 panels. Feedback

wulfman wulfman at wulfman.com
Mon Oct 26 22:54:20 CDT 2015


To effectively drill in plastics you need to run the drill press on the
highest speed you can
and use a freshly sharpened drill bit.

It kinda melts its way through.

On 10/26/2015 8:28 PM, Bob Rosenbloom wrote:
> On 10/26/2015 8:05 PM, rod wrote:
>> Hi Guys
>>         I need to get some comments on the following.
>>
>>     1. Would a matt finish be better than the current glossy one?
>>     2. Should the round holes be pre-drilled?
>>
>> Regards
>> Rod
>
> I would prefer the holes be drilled. It's not easy to drill the
> plastic as I found out, with small chips around the edges.
> And that was with a bit made for plastic.
>
> Bob
>


-- 
The contents of this e-mail and any attachments are intended solely for the use of the named
addressee(s) and may contain confidential and/or privileged information. Any unauthorized use,
copying, disclosure, or distribution of the contents of this e-mail is strictly prohibited by
the sender and may be unlawful. If you are not the intended recipient, please notify the sender
immediately and delete this e-mail.



More information about the cctalk mailing list