cost of low-quantity PCBs with hard gold over nickel edge card connectors

[Eric Smith]

On Wed, Feb 18, 2015 at 8:09 PM, Jon Elson <elson at pico-systems.com> wrote:
> I use E-Teknet in Arizona almost exclusively.  They are quite reasonable for
> generic boards.  They DO charge extra for gold fingers.  I haven't had any
> gold finger boards done recently, but I think it will add $50 - $100 to the
> cost of a small lot of boards.

Thanks for the tip. A $50-100 adder for a small lot suits me just fine.