Hi Steve I see. You were asking if anyone had a working Poly-88. Yes, I believe mine is likely still working. I also have a 8813 that was working when I put it away. At the VCF, I was talking to another fellow about the video board used on the Poly-88. It was said by the other person that the board was basically copied by others and some even had the same error, causing distortion of the first line by incorrect timing of the H retrace time, on many monitors. Dwight ------------------------------ *From:* Steve Lewis &lt;lewissa78(a)gmail.com&gt; *Sent:* Sunday, August 6, 2023 4:52 PM *To:* General Discussion: On-Topic and Off-Topic Posts < cctalk(a)classiccmp.org&gt; *Cc:* dwight &lt;dkelvey(a)hotmail.com&gt; *Subject:* Re: [cctalk] Re: VCF this weekend, any one up for a trade? Oh it wasn't my Poly88 - but the person who had it, they just didn't have a CRT or screen to test it out with. So it may be working fine. Original owner, said he put it together himself (and 16K). On Sun, Aug 6, 2023 at 3:11 PM dwight via cctalk &lt;cctalk(a)classiccmp.org&gt; wrote: My Poly-88 should be working but I've not played with it for a few years. The last time I had it up and doing something was at the last MakerFaire . What Is your issue? Dwight ________________________________ From: Steve Lewis via cctalk &lt;cctalk(a)classiccmp.org&gt; Sent: Thursday, August 3, 2023 10:19 PM To: General Discussion: On-Topic and Off-Topic Posts < cctalk(a)classiccmp.org&gt; Cc: Steve Lewis &lt;lewissa78(a)gmail.com&gt; Subject: [cctalk] Re: VCF this weekend, any one up for a trade? I can't make it to VCF this weekend - though I'm hoping to make it to the one in September. I actually am looking for something: any working IEC device for a C64 (1541 drive, printer, plotter?). More for an experiment than collection, but do prefer clean and presentable. Earlier this year, I reached someone with a working Poly-88. But then in March they reported health issues and hospital stays, so I haven't heard since. Would be interested if anyone else is aware of a still-working one. We're still working on recovery of an IBM 5100 "launch title" tape (analytic functions) - practicing with other tapes first. Its 2-channel deal so far isn't quite that straightforward. But if the Tektronics folks can do it with their QIC tapes, I'm somewhat hopeful we can too (although late 70s/early 80s Tektronic is apparently a more proper IEEE-488). Only thing I could offer right now is a fairly not-working 5110 (display don't work, PSU don't work, cards don't work - but the case is pristine). -Steve On Thu, Aug 3, 2023 at 8:49 PM Fred Cisin via cctalk < cctalk(a)classiccmp.org&gt; wrote: and