19 Dec
2024
19 Dec
'24
2:15 p.m.
It's always SQE with thicknet. Too much or too little.
On Thu, Dec 19, 2024, 3:03 PM Peter Ekstrom via cctalk <
cctalk(a)classiccmp.org> wrote:
I just learned what SQE does. I had to enable it on my
AUI and it seems the
collision detection is happy now.
-Peter
On Thu, Dec 19, 2024 at 9:41 AM Peter Ekstrom <epekstrom(a)gmail.com> wrote:
Hi all,
This may be a dumb question but I am a bit stumped. I can't seem to find
any helpful info in the manuals. I have a DEQNA installed in my 11/23+
and
I have run a NETGEN using the QNA driver. When
NETINS runs I start seeing
messages like these on the console:
Event type 5.14, Send failed
Occurred 19-DEC-24 09:30:11 on node 10.1 (TYCHO)
Line QNA-0
Failure reason = Collision detect check failed
So obviously the link isn't working, but I find nothing helpful about
where to start looking regarding the failed collision detect check. The
line is on:
NCP>show line qna-0 status
Line status as of 19-DEC-24 09:36:31
Line State
QNA-0 On
I have an Ethernet transceiver (I have 2 and have tried both, they worked
last time I used them) connected to the DEQNA harness, and a cable
connecting it to an old 10Base-T hub. I know that hub works because I
have
a couple of other systems (OS/2 laptop and an
AS/400) connected to it.
So does anyone have any ideas of where I can start?
Thanks in advance!
Peter