Hello,
I have some images, I'm uploading them to this folder
https://1drv.ms/f/s!AimuHQefzYTDgrwm_KAaNUdZRaw6IA?e=MwLOVN
I will add mcoe 2005 , and oe 2001
Also
https://1drv.ms/f/s!FimuHQefzYTDg3RXTWNDb0VLVVNnMCQM?e=5fe0c5
patches
-----Original Message-----
From: Eric Smith via cctalk <cctalk(a)classiccmp.org>
Sent: Thursday, June 20, 2024 11:15 AM
To: General Discussion: On-Topic and Off-Topic Posts <cctalk(a)classiccmp.org>
Cc: Eric Smith <spacewar(a)gmail.com>
Subject: [cctalk] Re: wanted: HP-UX 11i v1 (11.11) install media or images
On Thu, Jun 20, 2024 at 2:13 AM Adrian Godwin via cctalk < cctalk(a)classiccmp.org>
wrote:
I'm interested in this. I'm looking at the
bottom end, the bus and
cards, but there may be information we can share.
That's where I'm starting, too. I'm using a 16500A (rather than a B, C, or
1670x) because it should be much simpler to figure out how the processor accesses the
registers and memory of the modules. Then it should be possible to build something like a
USB4 PCIe alternate mode interface to the analyzer backplane, replacing the analyzer's
CPU card.
I don't intend to reverse-engineer details of how the modules actually work. Instead,
I want to run the real 16700 software in simulation or binary translation on a PC.
The tricky part is going to be figuring out how the module correlation circuitry on the
CPU board works, because my plan requires reproducing that.