[cctalk] ADM3a screen rot.

A quick note on ADM3a screen rot... my vintage collection resides in a cool (60-72 degrees F) dry basement. My "pride and joy" ADM3a (I have several) was just starting to show a few bubbles at the corners last September. I was pulling out some parts units on Friday and noticed that one had a much better screen than I remembered. Thinking that I might swap screens, I took a close look at "PnJ" and discovered to my horror that most of the lower half of the screen had "melted". "PnJ" was on a shelf, below eye level, nowhere near a vent or other source of heat. I was so annoyed that I immediately started cleaning/repair without taking any pictures (sorry). Fortunately, there does not appear to be any corrosion from the "goo". I completely desoldered and removed the keyboard assembly to get all of the crud out of (and out from under) it. The mainboard is a fully socketed example and the crud is down in several of the sockets. I'm still working on that. Anyway, the take away is don't assume (like I did) that the ruined ADM3as you see are the result of temperature extremes. It can happen anywhere. Keep a close eye on yours if you have one. Bill S. -- This email has been checked for viruses by Avast antivirus software. www.avast.com